SFC-VTEC Main Menu
Functions●
Compatibility List & Wiring Diagrams●
Basic Introduction●
Testing and Mode Switching●
How to use the SFC-mode (fuel mapping)●
How to use the VTEC-mode●
How to use the Speedo & Speed Limit removal●
Other Functions●
Troubleshooting●
SFC-VTEC Wiring for M2 Cars
Compatible Cars (M2) Chassis Type Engine Name Year Model ECU Location
Mirage CK4A 4G92 10/95 ~
Left foot area of Passenger-side
seat
Cyborg CJ4A 4G92 10/95 ~
Left foot area of Passenger-side
seat
Asti CJ4A 4G92 1/96 ~
Left foot area of Passenger-side
seat
Lancer CK4A 4G92 10/95 ~
Left foot area of Passenger-side
seat
Aeterna E54A 6A12 10/93 ~ Rear of Center Console
Emeraude E54A 6A12 10/94 ~ Rear of Center Console
Galant E54A 6A12 10/93 ~ Rear of Center Console
Diamante F36A 6G72 1/95 ~ Rear of Center Console
FTO DE3A 6A12 10/94 ~
Left foot area of Passenger-side
seat
Instructions:
Turn off the Engine, and remove the (-) negative ground from your battery1.
Remove all covers, etc., and locate your ECU2.
Following the diagram below, wire your unit accordingly.3.
Use pliers to securely fasten the electrotaps.
❍
Use proper crimping tools to fasten the terminals securely.❍
If you see wire that originally had a ring-shaped connector, please make sure that it gets
properly grounded.
❍
On some models, there will be wires that are not used, or left disconnected. Please use
electrical tape to terminate properly.
❍
4.
Once the wiring is complete, set the dipswitches to the configuration that matches your engine, and
install the unit in your desired location.
5.
Re-connect your battery terminal, and confirm operation of the device.6.
http://asia.vtec.net/beystock/field/sfc-vtec/x01_sfcv0m2.html (1 von 2) [06.07.2000 22:48:39]
Komentáře k této Příručce