V-Tec 2-wire Uživatelský manuál stáhnout pdf (Strana 9)

SFC-VTEC Main Menu

Functions●

Compatibility List & Wiring

Diagrams

●

Basic Introduction●

Testing and Mode Switching●

How to use the SFC-mode (fuel

mapping)

●

How to use the VTEC-mode●

How to use the Speedo & Speed Limit

removal

●

Other Functions●

Troubleshooting●

Steps to properly testing your unit.

Switch Definitions

Short Hold - ( < 0.5 seconds )

Long Hold - ( 0.5 ~ 2.0 seconds )

Continued Hold- ( > 2.0 seconds )

1) Leaveyour SFC-VTEC unit's main switch in the OFF position, and startand warm

your car.

During this time, check for any "check engine" lights, and make sure that the

engine is running smoothly.

●

Turn the engine off, and put your ignition key to the OFF position.●

2) Check the dipswitchsettings one last time before turning the SFC-VTEC's main

switchto the ON position, and then turn on your engine.

During this time, check for any "check engine" lights, and make sure that the

engine is running smoothly.

●

3) Check the display onthe SFC-VTEC unit.

Confirm that the various switches (MODE, UP, DOWN) are illuminated green.

●

Turn on the SFC-VTEC by depressing the MODE switch, and confirm that the

mode status light is shining at "SFC."

●

Following theinstructions in the second half of this page, please change the mode

to "VTC"

●

4) Step on theaccelerator, and confirm that the SFC-VTEC's tachometer ismatched with

the tachometer in your dash.

For cars with driveshaft-tachometers, the readouts will be slightly differ at higher

●

Steps to properly testing your unit

http://asia.vtec.net/beystock/field/sfc-vtec/x01_sfcv004.html (1 von 2) [06.07.2000 22:47:22]

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Komentáře k této Příručce

Žádné komentáře

V-Tec 2-wire Uživatelský manuál Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Systémy intercom pro domy V-Tec 2-wire